Rockford 2014+ Harley-Davidson Road/Street Glide Fairing/Bag Speakers w/ 4CH Amp
The next step in motorcycle performance, our M5 audio kits are the loudest and clearest audio systems. Full Throttle Output: Audio engineered to perform on the open road. Speakers and amplifiers specifically tuned and designed to not only overcome wind, road, and exhaust noise, but to give you that second to none audio experience on your bike. RF3 (Rockford Factory Fit and Finish): Designed and engineered to match and compliment the factory fit and finish of your bike. These components are purpose built to the exact specifications to ensure the best-in-class fitment and look. Element Ready: Purpose built for the harsh motorcycle environment. The speakers and amplifier are designed to stand up to water, dirt, UV, and motorcycle vibration, ensuring that your audio system will stand the test of time. Please review compatibility chart in the official website.
THIS LISTING INCLUDES:
(2) Rockford Fosgate TMS65 6.5" fairing speakers
(2) Rockford Fosgate TMS57 5x7" saddlebag speakers
(1) Rockford Fosgate M5-800X4 800W 4-channel amp
(1) Rockford Fosgate RFK-HD14 amp installation kit
TMS65 Features:
-Designed to fit your Harley's fairing and front lower speaker locations
-Element-Ready design is weather and water resistant
-Neodymium Tweeter with Integrated Phase Plug and ASA Grill
-Built-in tweeter crossover
-Grilles for Fairing and rear Tour-Pak included
-Power handling: 75 watts RMS (150 watts peak)
TMS65 Specifications:
Speaker Type: 2-Way Coax
Midrange Size: 6.5"
Voice Coil Diameter: 1.40"
Frequency Response (Hz): 56 Hz - 20 kHz
Nominal Impedance (Ohms): 4-Ohm
Sensitivity (dB @ 2.83V/1M) : 94 dB
Power Handling (MAX): 150 Watts
Power Handling (RMS): 75 Watts
TMS57 Features:
-Designed to fit your Harley's hardshell bags
-Element-Ready design is weather- and water-resistant
-Neodymium Tweeter with Integrated Phase Plug and ASA Grill
-Integrated 6dB Crossover with High Power Polyester Capacitor
-Handles up to 100 watts RMS (200 watts peak)
-Factory H-D connector for plug-n-play operation
TMS57 Specifications:
Speaker Type: 2-Way Coax
Midrange Size: 5' x 7'
Frequency Response (Hz): 61 Hz - 20 kHz
Nominal Impedance (Ohms): 4-Ohm
Sensitivity: 89 dB (1w/1m) 92 dB (2.8V @ 1m)
Power Handling (RMS): 100 Watt
M5-800X4 Features:
-Element Ready design with integrated harness & panel seals
-C.L.E.A.N. input/output clip detection and indicator LEDs
-Constant Power provides instantaneous delivery of output over varying impedance loads
-Focused mass heat sink allows critical aluminum material to be located around hottest internal devices
-Top mounted control panel with Element Ready smoked lens cover
-Low Impedance Stability
-Proprietary Class-AD technology allows amplifier to produce more power with less current draw
-MESHA 4 reduces MOSFET temps, lowers distortion, increases durability and prolongs device life span
-Balanced Differential Inputs eliminates noise picked up by signal cables
M5-800X4 Specifications:
Number of Channels: 4
Max Power: 800 Watts
RMS Power:
100 Watts x 4 @ 4
100 Watts x 4 @ 2
200 Watts x 2 @ 4 Bridged/Mono
Dynamic Power (PVC/PowerCube):
125 Watts x 4 @ 4
200 Watts x 4 @ 2
400 Watts x 2 @ 4 Bridged/Mono
Frequency Response: 10 Hz-50 kHz
Input Sensitivity: 150mVrms-12Vrms
Circuit Topology Class: Class AD
Efficiency: Greater than 75%
THD: Less than 0.25%
Signal Input: Low-Level: 4 RCA
High-Level: (2) 4-Pin Molex
Tone Controls: Front/Rear: 0-14dB @ 12.5kHz
Front/Rear: 0-18dB @ 45Hz
Crossover Controls: High-Pass-50 Hz - 250 Hz @ 12dB/Octave Butterworth
Low-Pass-50 Hz - 250 Hz @ 12dB/Octave Butterworth
Cooling: Convection
Heatsink: Extruded Aluminum
Operating Voltage: 9 - 16 VDC
Max. Current Draw (13.8V Sinewave)
55 A @ 4
85 A @ 2
90 A @ 4 Bridged
Dimensions: (H x W x D)
1.7" x 4.25" x 8.41"
(42.8 mm x 108 mm x 213 mm)
RFK-HD14M5 Features:
- FULL spec cable - meets or exceeds AWG (American Wire Gauge) requirements.
- 100% Pure Crystal-Oxygen Free Copper (PC-OFC).
- Plug and Play design for easy installation.
- Designed for use with 2014-Current Harley-Davidson Motorcycles.
- 90-degree harness included with amp install kit for Road Glide installations.
- Y-adaptors included in amp install kit supports expansion of lower fairing, saddlebag, or Tour-Pak speakers.
- T-harness integration supports front/rear fader control (requires "Rockford Fosgate 2014+ All Bikes" flash).
- Includes mounting brackets for Bat Wing and Shark Nose fairings.
- Includes Boom! Audio bypass plugs for factory Harmon/Kardon amplified systems.
RFK-HD14 Specs:
Battery PWR/GND Gauge: 8 AWG
Fuse Type: MAXI
Fuse Size: 60 Amp
Amplifier PWR/GND Gauge: 8 AWG
Speaker Wire Gauge: 16 AWG
FEATURES:
-No drilling or cutting required
-Plug and Play design for easy installation
-Kits bolt to factory attachment points
-Direct connect wiring harnesses for Harley-Davidson models
-Speakers are custom tuned so you can hear music over wind, road & exhaust noise at highway speed
-Y-adaptors included in amp install kit supports expansion of lower fairing, saddlebag, or Tour-Pak speakers
-T-harness integration supports front/rear fader control (requires "Rockford Fosgate 2014+ All Bikes" flash)
-T-harness features loop-thru for Digital Signal Processor (DSR1 sold separately)
-90-degree harness included with amp install kit for Road Glide installations
-Factory Harley-Davidson radio must be flashed to use this kit
-Quality & Performance tested using proprietary RATS (Rockford Automated Testing System)
-Klippel Verified certification program delivers the best possible loudspeakers
-2-Year Warranty
SPECS:
Amplifier Type: External
Total Power: 800 Watts
Grille/Trim Ring Included: Yes
Mounting Hardware: Yes
Unit Weight: 20 lb>
